https://www.cdebyte.com/Aboutus-NewProductExpress 🍂Shop Now–25% OFF Ends Nov 30! BUYBUYShop
fx1fx2Share
English English
FRESCN
Home >Modem>Profinet>Profinet Gateway
Single-port Profinet Gateway
Single-port Profinet Gateway
Single-port Profinet Gateway
Single-port Profinet Gateway
Single-port Profinet Gateway
Single-port Profinet Gateway
PN1-D25P Single-port Profinet to ModBus gateway Support Siemens PLC networking RS485/422 compatible with RS485 Easy configuration

[Communication interface]：RS485+RS422+RJ45

[Working voltage]： DC 8~28V

[Installation method]：Guide rail installation

[Product size]：55*30*80mm

[Product weight]：130±5g

[Introduction]：PN1-D25 is a Profinet to Modbus RTU gateway used to map Modbus data to Profinet.The shell adopts three-proof coating, which is Anti-Fungal, Anti-Humidity, and Anti-Salt Spray.
Use GSD files for integration, code-free reading and writing of Modbus devices, and quickly set up data and transfer it to the PLC. The gateway provides 1 RS485 and 1 RS422 (compatible with RS485) interfaces, each supporting 32 command nodes, for a total of 64 command nodes. All Modbus commands are loaded in module form, and the memory mapping relationship between Profinet and Modbus is intuitive and can be queried in STEP 7 or TIA Portal software. The status byte can be loaded to query the connection status of the Modbus device and monitor the device status in real time.

Send Inquiry
Purchase
File Downloads Compare
PIN
Label name illustrate
A1 RS485 A1 interface Serial port 1 RS485 A1 interface, 5.08mm terminal
B1 RS485 B1 interface Serial port 1 RS485 B1 interface, 5.08mm terminal
T+/A2 RS422 T+ interface/RS485 A2 interface Serial port 2 RS422 T+ interface/RS485 A2 interface, 5.08mm terminal
T-/B2 RS422 T-Interface/RS485 B2 Interface Serial port 2 RS422 T-port/RS485 B2 port, 5.08mm terminal
R+ RS422 R+ interface Serial port 2 RS422 R+ interface, 5.08mm terminal
R- RS422 R-Interface Serial port 2 RS422 R-interface, 5.08mm terminal
V- DC power supply negative pole DC (8~28V) power negative terminal, 5.08mm terminal
V+ DC power supply positive pole DC (8~28V) power positive terminal, 5.08mm terminal
X1P1 Network port 1 Standard RJ45 network cable interface
Reload button Restore to factory settings: Press and hold for 5 to 10 seconds and then release the power button; 
Device restart: When powered on, release the device after a short period of less than 2 seconds; 
Firmware upgrade: Press and hold the button in the power-off state, then power on, the device will enter the upgrade mode;