[Chip solution]:ASR6601
[Working frequency]: CN470~510MHZ
[Transmit power]:22dBm
[Communication distance]: 5.6km
[Product size]:14*20mm
[Product weight]:1.6g±1g
[Introduction]:E78-470LN22S (6601) is a standard LoraWan node module designed and produced by Ebyte. It works in the frequency band CN470~510MHZ. It supports CLASS-A/CLASS-C node types and supports two network access methods: ABP/OTAA. At the same time, this module has It has multiple low-power consumption modes, and the external communication interface adopts standard UART. Users can access the standard LoraWan network through simple configuration through AT commands. It is an excellent choice for IoT applications.
No. | Pin | Pin Direction | Pin Usage |
1 | GND | - | Ground wire, connected to the power reference ground |
2 | VCC | - | Power supply, range 2.5~3.7V (it is recommended to add external ceramic filter capacitors) |
3 | SETB | - | Low power wake-up pin |
4 | DIO1 | input /Output | NC (pin reserved) |
5 | BUSY | input /Output | NC (pin reserved) |
6 | I2C_SDA | input /Output | NC (pin reserved) |
7 | I2C_SCL | input /Output | NC (pin reserved) |
8 | UART_CTS | input /Output | NC (pin reserved) |
9 | UART_RTS | input /Output | NC (pin reserved) |
10 | GND | - | Ground wire, connected to the power reference ground |
11 | ANT | - | Antenna connector, stamp hole (50 ohm characteristic impedance) |
12 | GND | - | Ground wire, connected to the power reference ground |
13 | GND | - | Ground wire, connected to the power reference ground |
14 | GND | - | Ground wire, connected to the power reference ground |
15 | GND | - | Ground wire, connected to the power reference ground |
16 | XRES | input | External reset pin |
17 | ADC_IN | input | NC (pin reserved) |
18 | AUX | input /Output | NC (pin reserved) |
19 | SETA | input /Output | NC (pin reserved) |
20 | UART_RX | input /Output | UART RX pin |
21 | UART_TX | input /Output | UART TX pin |
22 | SWD_DATA | input /Output | SWD Data pin |
23 | SWD_CLK | input /Output | SWD Clock pin |
24 | GND | - | Ground wire, connected to the power reference ground |
25 | SPI_MISO | input /Output | SPI MISO test point, wired internally, cannot be used as external SPI |
26 | SPI_NSS | input /Output | SPI NSS test point, wired internally, cannot be used as external SPI |
27 | SPI_MOSI | input /Output | SPI MOSI test point, wired internally, cannot be used as external SPI |
28 | SPI_SCK | input /Output | SPI SCK test point, wired internally, cannot be used as external SPI |