https://www.cdebyte.com/Aboutus-NewProductExpress Christmas Mega Sale BUYBUYBuy
fx1fx2Share
English English
FRESCN
Home >Module>SPI/SOC/UART>Other
Wireless Module
Rf Module
15.4-Stack protocol
Wireless Module
Rf Module
15.4-Stack protocol
Ebyte 915MHz Rf Module Remote Control Iot Industrial 1w High Quality Wireless Transmitter Module

[IC]：

[Frequency]：915MHz

[Power]：30dBm

[Distance]：6.5km

[Size]：24*38.5mm

[Weight]：4.9±0.1g

[Introduction]：E70-915NW30S is the star network module, operating at 915MHz, based on originally imported TI CC1310 and 15.4-Stack protocol, with coordinator and terminal as a whole. There are long range, standard range and high-speed transmission modes. Maximum 200 nodes can send data to one coordinator. Use industry-standard AT commands for operating

Send Inquiry
Purchase
File Downloads Compare
1
No. Pin item Pin direction Application
1-3、17、30、31、46、47 GND Ground Ground electrode
4-15、18-21、25、33-35、39-41 NC Reserved pin Reserved, to be floated
16 LINK output For indicating the current network connection status of the module, it can be configured as drain open circuit output or push-pull output. For details, please refer to the parameter setting, a 1K protection resistor shall be connected in series externally (it can be suspended).
22 TCKC Input JTAG TCKC
23 TMSC Input JTAG TMSC
24 RESET Input Module reset pin, low level effective
26 M0 Input M1M0 The four working modes of the module are determined by the joint combination. When in use, a 1K protection resistor shall be connected in seriesexternally, and a 1M pull-up resistor shall be added (it shall not be suspended, otherwise, it can be grounded).
27 M1 Input M1M0 The four working modes of the module are determined by the joint combination. When in use, a 1K protection resistor shall be connected in seriesexternally, and a 1M pull-up resistor shall be added (it shall not be suspended, otherwise, it can be grounded).
28 VCC - Power supply：2.6V ~ 5.5V DC
29 VCC - Power supply ：2.6V ~ 5.5V DC
32 ACK Output The user indicates the data transmission result of the module, which is pulled down before transmission and pulled up after success. It can be configured as drain open circuit output or push-pull output. When it is used, a 1K protection resistor should be connected externally in series (it can be suspended).
36 RXD Input TTL UART inputs, connects to external (MCU, PC) TXD output pin. Can be configured as open-drain or pull-up input.
37 TXD Output TTL UART outputs, connects to external RXD (MCU, PC) input pin. Can be configured as open-drain or push-pull output
38 AUX Output To indicate module ’s working status & wakes up the external MCU. During the procedure of self-check initialization, the pin outputs low level. Can be configured aspush-pull output (suspending is allowed).
42 PA_EN Output Internal single chip microcomputer control PApin, high level effective, connected 45 pin
43 LNA_EN Output Internal single chip microcomputer control LNA pin, high level effective, connected 44 pin
44 LNA_EN Input Internal single chip microcomputer control LNA pin, high level effective, connected 43 pin
45 PA_EN Input Internal single chip microcomputer control PApin, high level effective, connected 42 pin
48 ANT -   Antenna 50 ohm impedance