Home >Module>SPI/SOC/UART>Other
E52-400NW30S LoRa MESH Networking Module UART Serial Port Long-Range Communication Simple to configure and easy to use

[Interface Type]:UART Serial Port

[Operating Frequency]:410.125–509.125 MHz

[Transmit Power]:30 dBm

[Communication Distance]:4.0 km

[Size]:40.5 * 25 mm

[Introduction]:The E52-400NW30S is a wireless serial port LoRa MESH networking module based on LoRa spread spectrum technology. It features a maximum output power of 30 dBm, an air data rate of up to 62.5 kbps, and supports a maximum baud rate of 460,800 bps. Operating on a default frequency band of 433.125 MHz, this LoRa MESH module utilizes a novel networking technology characterized by decentralized architecture, self-routing capabilities, network self-healing, and multi-level routing. It is ideally suited for a wide range of application scenarios, including smart homes, industrial sensors, wireless security and alarm systems, building automation solutions, and smart agriculture.

PIN
Pin number Pin Name Pin direction Pin Applications
1 GND - Ground wire, connected to power reference ground
2 VCC input Power supply VCC, supports DC 3.3~5.5V input.
3 BOOT input The default level is high; upon power-on, it is pulled low to input the bootloader.
4 TXD Output UART_TXD, serial port transmit pin
5 RXD input UART_RXD, serial port receive pin
6 DATA Output RF transmit indicator pin, default high level, active low level
7 NC - Not yet in use, NC recommended
11 ON - Antenna interface, 50Ω characteristic impedance
12 GND - Ground wire, connected to power reference ground
13 GND - Ground wire, connected to power reference ground
14 GND - Ground wire, connected to power reference ground
18 NC - Not yet in use, NC recommended
19 NC - Not yet in use, NC recommended
20 NC - Not yet in use, NC recommended
21 NC - Not yet in use, NC recommended
22 NRST input Reset pin, default high level, active low level
23 GND - power ground
24 NC - Not yet in use, NC recommended