Home >Module>LoRa>SX1262

E22-230T37S SEMTECH LoRa solution, 230MHz, 5W high power, relay networking,LoRa wireless module

[Chip solution]:-

[Frequency]:220.125~236.125MHz

[Transmission power]:37dBm

[Communication distance]:20km

[Size]:50*30.9mm

[Product weight]:10.8±0.1g

[Introduction]:E22-230T37S is a new generation of LoRa wireless module. It is a wireless serial port module (UART) based on LoRa solution. It has a variety of transmission methods, works in the 230MHz frequency band, TTL level output, and supports 4.5V-15V power supply voltage.


Main parameters Performance
Remarks
Minimum Typical Maximum
Working voltage (v)4.55~12 V15≥4.5V can guarantee the output power, the lower the voltage, the greater the supply current
Communication level (V)-3.3-There may be a risk of burning when using a 5V level, and a level conversion circuit is required
Working temperature (℃)
-40-85industrial design
Working frequency band (MHz)220.125-236.125Support ISM frequency band
power consumption5V emission current (mA)290031003300Tested under 50 ohm impedance, impedance mismatch may lead to excessive current, please provide at least 3.5A output power supply when using 5V power supply
12V emission current (mA)90011001300Tested under 50 ohm impedance, the impedance mismatch may cause the current to be too large, please provide a power supply with at least 1.5A output when using 12V power supply
Receive current (mA)384348-
Sleep current (uA)-2-software shutdown
Maximum transmit power (dBm)
363738-
Blocking power (dBm)
--10High-power radio frequency do not communicate at close range
Receiving sensitivity (dm)
-126-128-130Air rate 2.4 kbps
Air rate (bps)0.3k2.4k62.5kUser Programmable Control
Reference distance20kmSunny and open, urban area of Chengdu, antenna gain 5dBi, antenna height 2.5 meters, airspeed 2.4K.
launch length240 ByteSubpackage 32/64/128/240 bytes can be sent by command setting
cache capacity1000 Byte-
Modulation LoRaA new generation of LoRa modulation technology
Communication Interface
UART serial port
TTL level
Encapsulation
patchSMD
Interface
2.54mm-
Dimensions 50*30.9mm-
RF interfaceIPEX/stamp holeThe characteristic impedance is about 50 ohms