[Protocol]:NMEA0183 V4.1 and previous version,max updating frequency is 10Hz
[Certification]:Pending
[Package]:Half hole(SMT)
[Product weight]:0.8±0.1g
[Introduction]:E108-GN02S is a highly integrated, low-power, low-cost multi-mode satellite positioning and navigation chip. It can be used for GPS/GNSS positioning applications such as car navigation, smart wearable, and drone. It also provides software and hardware interfaces compatible with other module manufacturers,which greatly reduces the user's development cycle.
No. | Name | Details |
---|---|---|
1 | NC | N/A |
2 | NC | N/A |
3 | 1PPS | Positioning indicator, square wave will be output when positioning is successful |
4 | EINT3 | External interrupt 3,default:pull down,8 ma driving current |
5 | FORCE_ON | Sleep wake-up pin, pulled high when the module enters ultra-lowpower consumption.This pin exits the ultra-low power mode (the level of this pin is1.1V, if the control pin level is not 1.1V,Partial pressure treatment is required). |
6 | EINT0 | External interrupt 0,default:pull down,8 ma driving current |
7 | NC | N/A |
8 | RSTN | Reset pin, default pull up, pull down for resetting. |
9 | VCC_RF | RF power output, to power active antenna(equal to VCC) |
10 | GND | Ground |
11 | RF_IN | RF input |
12 | GND | Ground |
13 | GND | Ground |
14 | NC | N/A |
15 | NC | N/A |
16 | RSTN | Reset pin, default pull up, pull down for resetting. |
17 | EINT1 | External interrupt 1,default:pull down,8 ma driving current |
18 | TX1 | UART1 output(N/A, 2.8V communication level) |
19 | RX1 | UART1 input(N/A, 2.8V communication level) |
20 | TXD | UART output(AT port, 2.8V communication level) |
21 | RXD | UART input(AT port, 2.8V communication level) |
22 | VBKP | RTC power input, RTC must be powered so module can work(2V-4.2V) |
23 | VCC | Power supply(2.8V—4.2V) |
24 | GND | Ground |