[Chip solution]:ESP32-C6
[Operating frequency]:2412~2484MHz
[Supported protocol]:IEEE 802.11ax
[Communication distance]:180m
[Interface type]:UART I/O
[Introduction]:E101-C6MN4-XS is a dual-mode ble WiFi module based on the built-in ESP32-C6 series chip solution. It supports Wi-Fi 6 and low-power ble 5.3 protocols. The WiFi module is small in size and integrates a variety of peripherals, including UART, I2C, I2S, infrared remote control module, temperature sensor, and analog/digital converter. It also has single-wire, dual-wire, and four-wire SPI interfaces. This dual-mode ble WiFi module can be used in smart home, industrial automation, healthcare, consumer electronics and other fields.
Name | Serial Number | Type 1 | Function |
GND | 1, 2, 11, 14,36∼53 | P | Ground |
3V3 | 3 | P | Power supply |
NC | 4 | — | Empty pin |
IO2 | 5 | I/O/T | GPIO2, LP_GPIO2, LP_UART_RTSN, ADC1_CH2, FSPIQ |
IO3 | 6 | I/O/T | GPIO3, LP_GPIO3, LP_UART_CTSN, ADC1_CH3 |
NC | 7 | Empty pin | |
EN | 8 | I | High level: chip enable; low level: chip shutdown; |
Note that the EN pin cannot be left floating. | |||
IO4 | 9 | I/O/T | MTMS, GPIO4, LP_GPIO4, LP_UART_RXD, ADC1_CH4, FSPIHD |
IO5 | 10 | I/O/T | MTDI, GPIO5, LP_GPIO5, LP_UART_TXD, ADC1_CH5, FSPIWP |
IO0 | 12 | I/O/T | GPIO0, XTAL_32K_P, LP_GPIO0, LP_UART_DTRN, ADC1_CH0 |
IO1 | 13 | I/O/T | GPIO1, XTAL_32K_N, LP_GPIO1, LP_UART_DSRN, ADC1_CH1 |
IO6 | 15 | I/O/T | MTCK, GPIO6, LP_GPIO6, LP_I2C_SDA, ADC1_CH6, FSPICLK |
IO7 | 16 | I/O/T | MTDO, GPIO7, LP_GPIO7, LP_I2C_SCL, FSPID |
IO12 | 17 | I/O/T | GPIO12, USB_D- |
IO13 | 18 | I/O/T | GPIO13, USB_D+ |
IO14 | 19 | I/O/T | GPIO14 |
IO15 | 20 | I/O/T | GPIO15 |
NC | 21 | — | Empty pin |
IO8 | 22 | I/O/T | GPIO8 |
IO9 | 23 | I/O/T | GPIO9 |
IO18 | 24 | I/O/T | GPIO18, SDIO_CMD, FSPICS2 |
IO19 | 25 | I/O/T | GPIO19, SDIO_CLK, FSPICS3 |
IO20 | 26 | I/O/T | GPIO20, SDIO_DATA0, FSPICS4 |
IO21 | 27 | I/O/T | GPIO21, SDIO_DATA1, FSPICS5 |
IO22 | 28 | I/O/T | GPIO22, SDIO_DATA2 |
IO23 | 29 | I/O/T | GPIO23, SDIO_DATA3 |
RXD0 | 30 | I/O/T | U0RXD, GPIO17, FSPICS1 |
TXD0 | 31 | I/O/T | U0TXD, GPIO16, FSPICS0 |
NC | 32 | Empty pin | |
NC | 33 | Empty pin | |
NC | 34 | — | Empty pin |
NC | 35 | — | Empty pin |